|
Starting situation with Sematic Encoder System© controller 1.0-2.0-2.1 
Disconnect the controller Sematic Encoder System© controller
 
Connect the green terminals kit for compatibility (kit = B066AAFX+B066AAEX)
 
Connect the SDS© rel.3 controller
Remove the red power cables which goes to the transformer (the transformer is no more to be used ... you can also remove totally)
 
Connected directly the Voltage power (115-230 Vac 50-60 Hz ... tollerance 90-290 Vac) using the black cable supplied
This is what you have at the end ... you can now give power. Don't forget to make a learning cycle and to set the parameters.
 Up to you to use
The on board controls |  | or the Handset |  | Last Update 13-02-04
| 
